If the computer starts normally, move the memory module to a different connector and restart the computer. Verify that the computer is plugged into a working electrical outlet and that you have pressed the power button. Serial or parallel port test failure. An error in the address decoding circuitry in the memory has occurred. Slave interrupt mask register failure. Interrupt vector loading failure.
|Date Added:||27 July 2007|
|File Size:||39.51 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If the problem persists, reinstall the card that you removed, remove a different card, and then restart the computer. If you receive this message after you make changes in the system setup program, enter the system setup program and restore the original value s.
Videk Memory Test failure. Continue until you have identified a faulty connector or reinstalled all modules without error.
Dell Dimension – Wikipedia
Reseating the memory modules may fix the beep code errors in the following table. Reinstall all USB devices, check cable connections, and 4600c restart the computer. Unexpected interrupt in protected mode. A possible video card failure has occurred.
If the computer has a video card, remove the card and reinstall itand restart the computer. If the problem persists, reinstall the cards that you removed, remove a different card, and then restart the computer. The operating system cannot be located on drive A or drive C. Repeat this process for each 46600c.
Search for video ROM failure. Memory modules are detected, but a memory configuration or compatibility error exists. Strike F1 to retry reboot, F2 for setup utility. A possible floppy or hard drive failure has occurred. An interrupt channel on the system board failed to POST.
To eliminate the possibility of a faulty memory connector, remove all memory modulesreinstall one memory module if the computer supports a single moduleand then restart the computer. If the problem still exists, install a video card that you know works and restart the computer. Verify that the vidro modules that you are installing are compatible with your computer. Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems.
Determine if a conflict exists by removing a card and then restarting the computer.
An error occurred with the keyboard connector. If the computer 460c0 normally, move the memory module to a different connector and restart the computer. Check the interface cable at both ends.
If the computer starts normally, troubleshoot the last card removed from the computer for resource conflicts see “Resolving Software and Hardware Incompatibilities” in your Owner’s Manual. An error is occurring on the timer on the system board.
When the computer starts normally, the lights flash. Error in the DMA controller on the system board.
Dell Dimension C Specs – CNET
The system configuration information in the system setup program is incorrect or the battery charge may be low.
The hard drive is not working or is not configured correctly. The keyboard or system board may need 4600v be replaced. To help you troubleshoot a problem, your computer is equipped with four lights on the back panel labeled “A,” “B,” “C,” and “D. Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board. If you hear one of the following beep codes, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance.